eSUN S200 Standard Resin

Packaged in a durable plastic bottle.

Technical Data Sheet_EN (12,71 MB)

– General Purpose Resin, Compatible to most LCD printers and DLP with LED UV.
– High Hardness 88 shore D, Low Shrinkage
– Faster Printing Speed
– Low Odor

Resin parameters:
Solidify wavelength: 395nm to 405nm
Hardness (D): 88D
Viscosity (25C,mPa.s): 100 to 150 mpa.s
Density: 1.07 to 1.12 g / cm3
Shrinkage of Vol.: 3.72%-4.24%

Physical Properties:
Flexural strength (Mpa): 59Mpa to 70Mpa
Flexural Modulus (Mpa): 1.88 to 2.38
Tensile strength (Mpa): 35Mpa to 42 Mpa
Elongation at break (%): 11% to 20%
Hardness (D): 88D

Precautions:
1. Storage
1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
Avoid any dusty or moist environment.

2. Usage:
1) Shake well before use. Avoid any direct sunlight during usage.
2) Keep it away from the children. Do not put in mouth.
3) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.
4) By skin contact please wash with plenty of water immediately. Seek medical advice if necessary.
5) Clean finished model with alcohol (>95%) for about 30 seconds.

Before choosing eSUN resins for your LCD/DLP 3D printers, please confirm that the UV wavelength of your 3D printer is 405nm. Thoroughly tested and perfectly compatible to our EPAX X1 LCD printer, Anycubic Photon and Wanhao D7.