Making 3d Printing Affordable!

0 items$0.00

No products in the cart.

PolyLite™ LW-PLA Bright Green 1.75mm Filament

$59.90

PolyLite™ LW-PLA is a special foamed PLA designed to print with similar settings as regular PLA but with half the weight.

0.8kg - Light Green

In stock

ePLA-LW is mainly used for lightweight parts and is widely used in fields such as DIY model aeroplanes, drones, and COSPLAY props.

Print Settings:

eSun ePLA-ST
Diameter 1.75mm2 ±0.03
Print Temp 190-210ºC (please read description)
Hot bed 30-50ºC (optional)
Printing Speed: 25mm/s – 60mm/s
Fan: ON

Direct Drive:
Retraction Distance: 3mm
Retraction Speed: 40mm/s
Indirect Drive:
Retraction Distance: 6mm
Retraction Speed: 60mm/s

Drying Settings: 55˚C for 6h
(Only if the material has absorbed moisture)

Surface: Masking paper, PVP solid glue, glass board, carbon fibre board, PEI

What is the difference between active foaming and passive foaming?

PolyLite™ LW-PLA is not an active foaming filament, which means it will not foam when extruded from the nozzle depending on the temperature. PolyLite™ LW-PLA is already pre-foamed.

What are the pros and cons between active and passive foaming?

Active foaming:
You need to heavily modify your printing settings depending on the temperature and setup to compensate the foaming expansion of the material when printing.
You need to print at very high temperature to achieve light weight results (~250˚), these high temperatures will create a lot of defects on the print such as stringing and blobs.
At very high temperature, active foaming can achieve lighter print than passive foaming however the print may suffer of serious stringing defects.

Passive foaming:
You do not need to change any settings from your regular PLA settings (slight increase retraction) as PolyLite™ LW-PLA will offer light weight results even when printing at very low temperature (~190˚C).
The lower the temperature the higher quality the print.

 

PolyLite™ LW-PLA is designed for ease of print and strong rigidity. For more information check out the review below about PolyLite™ LW-PLA for RC Plane application.

Weight0.8 kg
Dimensions210 × 210 × 50 cm
Brand

Colour

Light Green

Reviews

There are no reviews yet.

Be the first to review “PolyLite™ LW-PLA Bright Green 1.75mm Filament”

Your email address will not be published. Required fields are marked *

SKU: PMKR-PLA-LW-GREEN Category: Tags: , , ,