Engineering – ABS Like Rapid Photopolymer Resin

Packaged in a durable aluminium bottle

– Improved ABS Like resin, Compatible with most LCD printers using 405 nm wavelength light.
– 82shore D hardness, Not brittle, Low Shrinkage
– Faster Printing Speed
– Low Odour

Compatible for monochrome screen printers and color screen printers, printing without residual film or sediment. Enjoy a high successful printing rate.

Properties:
Solidify wavelength: 395nm to 405nm
Viscosity (25C,mPa.s): 600 to 800 mpa.s

Flexural strength (Mpa): 36Mpa to 49Mpa
Flexural Modulus (Mpa): 900 to 1100
Tensile strength (Mpa): 30Mpa to 40 Mpa
Elongation at break (%): 32% to 38%
Hardness (D): 80-83

Precautions:
1. Storage
1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
Avoid any dusty or moist environment.

2. Usage:
1) Shake well before use. Avoid any direct sunlight during usage.
2) Keep it away from children. Do not ingest.
3) Wear gloves before use to avoid direct skin contact and keep the room ventilated.
4) In case of skin contact please wash immediately with plenty of water. Seek medical advice if necessary.
5) Clean the finished model with alcohol (>95%) for about 30 seconds.

Bottom Exposure Time: 25-30s on mono and 50-60 on colour when layer thickness is 0.05mm, recommend set to 40s.
Normal Exposure Time: 2.5 -3s on mono and 8-10s on colour when layer thickness is 0.05mm.
PS: Exposure time is proportional to layer thickness. The numbers above are for layer thickness 0.05mm.