Rapido Hotend 2F UHF Black

Exceptional thermal insulation

To ensure greater wear resistance and thermal insulation, the all-metal heatbreak is RCC coated. This also prevents heat creep and blockages caused by the filament, among other things.

Highly efficient heating unit

A rectangular ceramic heating unit delivers higher performance and reliably heats the hotend to 280 °C in just 39 seconds.

New heating block for high-speed printing

The new design of the heating block has a long heating area to enable high volume flows of up to 36 mm³/s. With these flow rates, high-speed applications are impressive!

Removable temperature sensor

The Rapido Hotend 2F uses a PT1000 temperature sensor suitable for high-temperature printing, which is easy to maintain and replace.

Optimised assembly

The Rapido Hotend 2F uses a new cable tie structure to prevent damage during installation. This optimised assembly simplifies the assembly process and makes it more convenient for the user. The heating element is fixed by a metal dome for quick and cost-effective maintenance.

Nozzle change with one hand

The titanium alloy screws, which ensure a firm connection between the heating block and the heat sink, are characterised by low thermal conductivity. This rigid structure allows for easy nozzle replacement with just one hand.

High filament compatibility

The hotend is compatible with all thermoplastic filaments, including but not limited to typical fibre composite filaments such as PLA, ABS, ASA, PETG, TPU, PC, PP, PA and PLA-CF, ABS-CF, PETG-CF, PA-CF /GF, PC-ABS, PAHT, PVA, PET-CF, PP-GF…

Included:

• 4 x M2.5×8 screws
• 2 x M2.5×5 screws
• 1 x M1.6 titanium screw
• 1 x H1.5 hexagon pin
• 1 x H2.0 hexagon pin
• 1 x H7.0/H10.0 open-end wrench
• 1 x Collet Clip
• 1 x Collet
• 1 x extension cable for the heater
• 1 x extension cable for the temperature sensor
• 3 x cable ties
• 1 x leaf spring
• 1 x silicone grease